Joy Technology Co.,Limited

1. To improve SMT production efficiency, the correct cleaning makes the ceramic nozzle to maintain a new state to work, to avoid the identification of errors, greatly improve production capacity.

2. Reduce unnecessary labor: the traditional cleaning method requires a lot of manual processing, the use of KC600, then do not need someone, all to the machine to complete.

3. Component miniaturization: miniaturization of components is bound to require the corresponding placement machine ceramic nozzle also miniaturization, which gives the ceramic nozzle cleaning has brought the problem, if the large ceramic nozzle can also be through the alcohol paint Wash, fine needle through the hole method, it is now a small patch machine nozzle only a few microns of the aperture to do nothing.

4. Lead-free effects: due to the good activity of lead, if the patch is slightly biased, after reflow soldering can also be corrected, but after lead-free, copper activity greatly weakened, if the patch deviation There is no chance of amendment.

5. Reduce the product non-performing rate of ceramic nozzle is not clean suction is not strong is likely to cause the components of the sliding and throwing phenomenon occurs, resulting in improved product non-performing rate

6. Reduce the purchase cost of ceramic nozzle: ceramic nozzle scrapped, a lot of time is due to dirty, or the resulting accident occurred.

7. Smaller distance: the current electronic equipment requires a smaller size, more powerful, so the circuit board components more and more dense, the distance is getting smaller and smaller, if the past patch slightly flat will not affect too Big, but now it may be on the neighbor's site, resulting in improved product non-performing rate.