Joy Technology Co.,Limited

According to customer 's feedback,Juki KE2050 machines often damage smt nozzle, the customer asked to correct the ATC.

After checking the working condition, according to customer 's feedback, such failures should not occur for the MSP parameters, check the ATC open and close. There is no exception in the normal production , then the motor and the controller will not be faulty. After suspected ATC position is wrong, but the parameters can not be changed with no reason, and the error will not be so serious.

After testing all the ATC nozzles, it is found that some of smt nozzles  head can not be sucked up, but  it can be sucked slowly, initially determined as the ATC coordinate offset, there is no ATC correction fixture on hand, ready to manually according to the deviation When the change, suddenly asked the customer whether the machine to the company after the change of what parts and their own maintenance and debugging of what place, the customer replied that the original YL origin sensor. Get the message immediately stopped manually modified ATC deviation, The Fist Mark position of the Fist Mark is nearly 0.1mm, because the 2050 machine, the origin position can be compensated by the software correction, so to correct the restart the machine, the test nozzle again, all through the , And did not appear to suck the phenomenon of smt nozzle.

In addition, after doing CPK accuracy confirmed that the L3 placement angle is a bit offset, then the rotation center and Head deviation correction, but the effect is not ideal. After careful inspection found that the head of the 3 head is not fastened with the pole, tighten the fixed screw After the machine everything is workable! smt nozzle of JUKI KE2050 machine 

According to customer 's feedback,Juki KE2050 machines often damage smt nozzle, the customer asked to correct the ATC.

After checking the working condition, according to customer 's feedback, such failures should not occur for the MSP parameters, check the ATC open and close. There is no exception in the normal production , then the motor and the controller will not be faulty. After suspected ATC position is wrong, but the parameters can not be changed with no reason, and the error will not be so serious.

After testing all the ATC nozzles, it is found that some of smt nozzles  head can not be sucked up, but  it can be sucked slowly, initially determined as the ATC coordinate offset, there is no ATC correction fixture on hand, ready to manually according to the deviation When the change, suddenly asked the customer whether the machine to the company after the change of what parts and their own maintenance and debugging of what place, the customer replied that the original YL origin sensor. Get the message immediately stopped manually modified ATC deviation, The Fist Mark position of the Fist Mark is nearly 0.1mm, because the 2050 machine, the origin position can be compensated by the software correction, so to correct the restart the machine, the test nozzle again, all through the , And did not appear to suck the phenomenon of smt nozzle.

In addition, after doing CPK accuracy confirmed that the L3 placement angle is a bit offset, then the rotation center and Head deviation correction, but the effect is not ideal. After careful inspection found that the head of the 3 head is not fastened with the pole, tighten the fixed screw After the machine everything is workable!